Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New

Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New

Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New

ATV / UTV / SXS. Direct replacement to your original unit.

Plug-and-play, direct fit, easy installation. Highest grade copper windings, resistant to 200 degrees Celsius. Connector, pick-up coil and rubber grommet included. All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part. Battery condition is extremely important.

No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced. We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues. Alternator resistance (Yellow to Yellow) : 0.4 ohms +/- 20% Pick-up 1 resistance (Blue to Green) : 215 ohms +/- 20% Number of wires : 5 Number of plugs : 2 Number of terminals : 5 Harness length - Stator to grommet (mm) : 80 Harness length - Grommet to plug (mm) : 400 Pick-up coil wire length - Coil to grommet (mm) : 35 Inside diameter (mm) : 40 Outside diameter (mm) : 113 Thickness (mm) : 20.

Before installing your new stator. Check the AC output of the stator.

Replace any burned or corroded connectors on stator and regulator/rectifier. Check and repair any melted wiring.

Use hi-temp dielectric grease on all connectors. Our stator may use a different wire color code than your original. All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound. More than 20 years of assisting mechanics around the world resolving the worst electrical problems made us know our stuff. When it comes to vehicle electrics, we definitively are the power in powersports. This item is in the category "Automotive\Parts & Accessories\Snowmobile Parts\Electrical Components".

The seller is "rmstator-canada" and is located in this country: CA. This item can be shipped to North, South, or Latin America, all countries in Europe, all countries in continental Asia, Australia.
Stator For Arctic Cat Bearcat Z1 XT EFI L/C 2009 2010 2011 2012 2013 2014 New